Roku SoundBridge Network Music Player User Manual download pdf (Page 7)

III. Hooking Up Your Home Network Hardware (Wired Ethernet or Wireless)

Ethernet Connection

Plug your cable into the jack provided on the right side of the rear of the unit. Connect your

Ethernet cable to a hub, switch or router on your home network. Alternatively, you can connect

SoundBridge directly to your computer (and bypass a hub/switch/router), but only with a

“crossover” cable (sold separately). Connect the other end of the cable to your network.

Wireless Connection

No need to install any additional hardware into SoundBridge. Please note that most, but not

all, wireless access points are compatible with SoundBridge. You can ﬁnd a list of supported

wireless hardware at www.rokulabs.com/support.

IV. Hooking Up Your Speakers or Stereo System

Connect your choice of audio cables into the back left side of SoundBridge depending on your

preferred connection option.

Audio cable connectors

Digital Audio Outputs AC Adapter Connection

Optical

Analog 1/8” Miniplug Wired Ethernet

Network Connection

Coax

Your SoundBridge has several audio connection options:

a. Connect your SoundBridge to a set of powered speakers by inserting the 1/8” cable from

your powered speakers into the Analog 1/8” Miniplug connector on SoundBridge.

Note: If your speakers have a male connector, you will need a female-to-female coupler

available from Radio Shack.

b. Connect the RCA (red/white) audio cable included with your SoundBridge to your stereo

system’s Aux or other “Line Input” and connect the other end of this cable to SoundBridge’s

Analog 1/8” Miniplug connector.

c. Connect to your stereo system using either coaxial SPDIF digital or optical SPDIF digital

(the SoundBridge has connectors for both) — cables sold separately.

Section 1: Getting StartedSection 1: Getting Started

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Roku SoundBridge Network Music Player User Manual Page 7